[PATCH 5/8] drm: atmel-hlcdc: extract clock setup into a dedicated helper

[Manikandan Muralidharan <manikandan.m@microchip.com>]

Factor clock enable, rate calculation, and divider selection out of
atmel_hlcdc_crtc_mode_set_nofb() into a new
atmel_hlcdc_crtc_setup_clock() helper, preparing for the addition
of LVDS and XLCDC clock bypass support.

Signed-off-by: Manikandan Muralidharan <manikandan.m@microchip.com>
---
 .../gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c    | 66 +++++++++++--------
 1 file changed, 39 insertions(+), 27 deletions(-)

diff --git a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
index c7e77bb2941a..6da428361c19 100644
--- a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
+++ b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
@@ -66,6 +66,42 @@ drm_crtc_to_atmel_hlcdc_crtc(struct drm_crtc *crtc)
 	return container_of(crtc, struct atmel_hlcdc_crtc, base);
 }
 
+static int atmel_hlcdc_crtc_setup_clock(struct atmel_hlcdc_crtc *crtc,
+					unsigned long mode_rate,
+					unsigned int *cfg,
+					unsigned int *mask)
+{
+	unsigned long prate;
+	int div, ret;
+
+	ret = clk_prepare_enable(crtc->dc->hlcdc->sys_clk);
+	if (ret)
+		return ret;
+
+	prate = clk_get_rate(crtc->dc->hlcdc->sys_clk);
+	if (!crtc->dc->desc->fixed_clksrc) {
+		prate *= 2;
+		*cfg |= ATMEL_HLCDC_CLKSEL;
+		*mask |= ATMEL_HLCDC_CLKSEL;
+	}
+
+	div = DIV_ROUND_CLOSEST(prate, mode_rate);
+	if (div < 2) {
+		div = 2;
+	} else if (ATMEL_HLCDC_CLKDIV(div) & ~ATMEL_HLCDC_CLKDIV_MASK) {
+		/* The divider ended up too big, try a lower base rate. */
+		if (!crtc->dc->desc->fixed_clksrc) {
+			*cfg &= ~ATMEL_HLCDC_CLKSEL;
+			div = DIV_ROUND_CLOSEST(prate >> 1, mode_rate);
+		}
+		if (ATMEL_HLCDC_CLKDIV(div) & ~ATMEL_HLCDC_CLKDIV_MASK)
+			div = ATMEL_HLCDC_CLKDIV_MAX;
+	}
+
+	*cfg |= ATMEL_HLCDC_CLKDIV(div);
+	return 0;
+}
+
 static void atmel_hlcdc_crtc_mode_set_nofb(struct drm_crtc *c)
 {
 	struct atmel_hlcdc_crtc *crtc = drm_crtc_to_atmel_hlcdc_crtc(c);
@@ -76,12 +112,10 @@ static void atmel_hlcdc_crtc_mode_set_nofb(struct drm_crtc *c)
 	struct atmel_hlcdc_crtc_state *state;
 	struct drm_device *ddev = c->dev;
 	struct drm_connector_list_iter iter;
-	unsigned long mode_rate;
 	struct videomode vm;
-	unsigned long prate;
 	unsigned int mask = ATMEL_HLCDC_CLKDIV_MASK | ATMEL_HLCDC_CLKPOL;
 	unsigned int cfg = 0;
-	int div, ret;
+	int ret;
 
 	/* get encoder from crtc */
 	drm_for_each_encoder(en_iter, ddev) {
@@ -100,33 +134,11 @@ static void atmel_hlcdc_crtc_mode_set_nofb(struct drm_crtc *c)
 		drm_connector_list_iter_end(&iter);
 	}
 
-	ret = clk_prepare_enable(crtc->dc->hlcdc->sys_clk);
+	ret = atmel_hlcdc_crtc_setup_clock(crtc, adj->crtc_clock * 1000,
+					   &cfg, &mask);
 	if (ret)
 		return;
 
-	prate = clk_get_rate(crtc->dc->hlcdc->sys_clk);
-	mode_rate = adj->crtc_clock * 1000;
-	if (!crtc->dc->desc->fixed_clksrc) {
-		prate *= 2;
-		cfg |= ATMEL_HLCDC_CLKSEL;
-		mask |= ATMEL_HLCDC_CLKSEL;
-	}
-
-	div = DIV_ROUND_CLOSEST(prate, mode_rate);
-	if (div < 2) {
-		div = 2;
-	} else if (ATMEL_HLCDC_CLKDIV(div) & ~ATMEL_HLCDC_CLKDIV_MASK) {
-		/* The divider ended up too big, try a lower base rate. */
-		if (!crtc->dc->desc->fixed_clksrc) {
-			cfg &= ~ATMEL_HLCDC_CLKSEL;
-			div = DIV_ROUND_CLOSEST(prate >> 1, mode_rate);
-		}
-		if (ATMEL_HLCDC_CLKDIV(div) & ~ATMEL_HLCDC_CLKDIV_MASK)
-			div = ATMEL_HLCDC_CLKDIV_MAX;
-	}
-
-	cfg |= ATMEL_HLCDC_CLKDIV(div);
-
 	if (connector &&
 	    connector->display_info.bus_flags & DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE)
 		cfg |= ATMEL_HLCDC_CLKPOL;
-- 
2.25.1