[PATCH 3/4] dt-bindings: mmc: cdns,sdhci: add SD6HC DDR50 read-path tuning

[tze.yee.ng@altera.com]

From: Tze Yee Ng <tze.yee.ng@altera.com>

DDR50 has no CMD19 tuning, so the SD6HC read path must be centred by
static, board/SoC-characterised PHY settings. Add three optional SD6HC
properties:

  - cdns,ddr50-read-dqs-delay:   DLL_SLAVE[7:0] read-DQS delay that centres
    the read eye (0-255).
  - cdns,ddr50-use-lpbk-dqs:     DQS_TIMING[21] read-DQS source
    (0 = phony, 1 = loopback).
  - cdns,ddr50-phony-dqs-timing: PHY_CTRL[9:4] phony DQS assertion timing
    (0-63) that positions the fabricated strobe relative to the returning
    DDR data; not produced by the Cadence timing calculation.

All three are disallowed for the SD4HC variant.

Signed-off-by: Tze Yee Ng <tze.yee.ng@altera.com>
---
 .../devicetree/bindings/mmc/cdns,sd6hc.yaml   | 27 +++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/Documentation/devicetree/bindings/mmc/cdns,sd6hc.yaml b/Documentation/devicetree/bindings/mmc/cdns,sd6hc.yaml
index d5ea2717904b..df86872603d0 100644
--- a/Documentation/devicetree/bindings/mmc/cdns,sd6hc.yaml
+++ b/Documentation/devicetree/bindings/mmc/cdns,sd6hc.yaml
@@ -74,6 +74,33 @@ properties:
     maximum: 1000
     default: 24
 
+  cdns,ddr50-read-dqs-delay:
+    description: |
+      SD6HC DDR50 read-DQS delay (DLL_SLAVE[7:0]) used to centre the read
+      eye. DDR50 has no CMD19 tuning, so this is a board/SoC-characterised
+      value. If absent, the driver default is used.
+    $ref: /schemas/types.yaml#/definitions/uint32
+    minimum: 0
+    maximum: 0xff
+
+  cdns,ddr50-use-lpbk-dqs:
+    description: |
+      SD6HC DDR50 read-DQS source (DQS_TIMING[21]): 0 = phony DQS,
+      1 = loopback DQS. If absent, the driver default is used.
+    $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [0, 1]
+
+  cdns,ddr50-phony-dqs-timing:
+    description: |
+      SD6HC DDR50 phony DQS assertion timing (PHY_CTRL[9:4]). Positions the
+      fabricated read strobe relative to the returning DDR data; the correct
+      value depends on the board's SD flight time and is not produced by the
+      Cadence timing calculation. If absent, the driver default
+      (REBAR_PULSE_CYCLES-1) is used.
+    $ref: /schemas/types.yaml#/definitions/uint32
+    minimum: 0
+    maximum: 0x3f
+
 required:
   - compatible
   - reg
-- 
2.43.7