Re: [PATCH v4 3/3] arm64: dts: qcom: Add Vicharak Axon Mini

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 6/12/26 6:16 AM, Ajit Singh wrote:
> On Wed, Jun 10, 2026 at 02:58:19PM +0530, Konrad Dybcio wrote:
>> On 6/7/26 1:36 PM, Ajit Singh wrote:
>>> Add DTS for the Vicharak Axon Mini board based on the Qualcomm
>>> QCS6490 SoC.
>>>
>>> This adds debug UART, eMMC, UFS, SDIO WLAN, USB 2.0 host, PCIe
>>> support along with regulators.
>>>
>>> The UFS ICE block is kept disabled because enabling it currently causes
>>> an SError during qcom_ice_create() on this board. UFS works without ICE.
>>>
>>> Signed-off-by: Ajit Singh <blfizzyy@gmail.com>
>>> ---
>>
>> [...]
>>
>>> +		vreg_l12c_1p8: ldo12 {
>>> +			regulator-name = "vreg_l12c_1p8";
>>> +			regulator-min-microvolt = <1800000>;
>>> +			regulator-max-microvolt = <2000000>;
>>> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
>>> +
>>> +			/*
>>> +			 * VREG_L12C_1P8 supplies the Ampak WLAN/BT module
>>> +			 * VDDIO and the external 32.768 kHz oscillator.
>>> +			 */
>>
>> Sorry for the long review timelines on the previous patch, many of us
>> were out for conferences..
>>
>> Is the oscillator used for that WLAN module? Would you ideally like to
>> be able to turn it on/off?
> 
> yes, oscillator is used for WLAN modules. Oscillator is powered from the same
> VREG_L12C rail as WLAN VDDIO, so there is no separate regulator control to put
> in pwrseq. So I think this will work fine?

Probably? My point is that you marked it as always-on, so it will *never*
turn off right now. For e.g. Qualcomm wifi, there's some timing spec that
needs to be met wrt delays between toggling various regulators and GPIOs
going to the module, hence I suggested you may need some pwrseq inbetween
to achieve reliable powering on/off

Konrad