[PATCH 1/2] merge_config.sh: do not print non-matching lines in the sed expressions

[Darren Hart <dvhart@linux.intel.com>]

The script picks up on comment lines and run into failed grep commands and
spew lots of warnings about "#" not being set and so forth.

sed will print non-matching lines without the -n option. Add -n and a p (print)
to each sed command. This will ensure only the CONFIG_* lines are used for
value comparison, and comment lines are ignored. # CONFIG_XYZ is not set are
still matched and not treated as comments. This addresses an issue Dmitry raised
without another pipe and call to grep.

Move the sed expression into a variable to avoid getting the regular expressions
in the two call sites out of sync.

Signed-off-by: Darren Hart <dvhart@linux.intel.com>
CC: Dmitry Fink <Dmitry.Fink@palm.com>
---
 scripts/kconfig/merge_config.sh |   10 ++++------
 1 files changed, 4 insertions(+), 6 deletions(-)

diff --git a/scripts/kconfig/merge_config.sh b/scripts/kconfig/merge_config.sh
index fda0139..a644724 100755
--- a/scripts/kconfig/merge_config.sh
+++ b/scripts/kconfig/merge_config.sh
@@ -25,11 +25,12 @@ MERGE_LIST=$*
 
 TMP_FILE=$(mktemp ./.tmp.config.XXXXXXXXXX)
 
+SED_CONFIG_EXP="s/^\(# \)\{0,1\}\(CONFIG_[a-zA-Z0-9_]*\)[= ].*/\2/p"
+
 # Merge files, printing warnings on overrided values
 for MERGE_FILE in $MERGE_LIST ; do
 	echo "Merging $MERGE_FILE"
-	CFG_LIST=`cat $MERGE_FILE | \
-	  sed 's/^\(# \)\{0,1\}\(CONFIG_[a-zA-Z0-9_]*\)[= ].*/\2/'`
+	CFG_LIST=`cat $MERGE_FILE | sed -n "$SED_CONFIG_EXP"`
 	for CFG in $CFG_LIST ; do
 		grep -q -w $CFG $TMP_FILE
 		if [ $? == 0 ] ; then
@@ -53,10 +54,7 @@ done
 make KCONFIG_ALLCONFIG=$TMP_FILE alldefconfig
 
 # Check all specified config values took (might have missed-dependency issues)
-cat $TMP_FILE | while read line; do
-	CFG=`echo $line | \
-		sed 's/^\(# \)\{0,1\}\(CONFIG_[a-zA-Z0-9_]*\)[= ].*/\2/'`
-
+for CFG in `sed -n "$SED_CONFIG_EXP" $TMP_FILE`; do
 	REQUESTED_VAL=`grep -w -e "$CFG" $TMP_FILE`
 	ACTUAL_VAL=`grep -w -e "$CFG" .config`
 	if [ "x$REQUESTED_VAL" != "x$ACTUAL_VAL" ] ; then
-- 
1.7.6.2