Re: [PATCH v2 3/4] clk: qcom: Add lpass audio clock controller driver for Glymur

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 9/25/26 10:46 AM, Srinivas Kandagatla wrote:
> Add support for the lpass audio clock controller found on Glymur based
> devices. This would allow lpass peripheral loader drivers to control the
> clocks and bring the subsystems out of reset.
> 
> Currently this patch only supports resets as the Q6DSP is in control of
> LPASS IP which manages most of the clocks via Q6PRM service on GPR rpmsg
> channel.
> 
> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@oss.qualcomm.com>
> Reviewed-by: Abel Vesa <abel.vesa@oss.qualcomm.com>
> ---

[...]

> +static const struct qcom_reset_map lpass_audiocc_glymur_resets[] = {
> +	[LPASS_AUDIO_SWR_RX_CGCR] = { 0xa0, 1 },
> +	[LPASS_AUDIO_SWR_WSA1_CGCR] = { 0xb0, 1 },
> +	[LPASS_AUDIO_SWR_WSA2_CGCR] = { 0xd8, 1 },
> +	[LPASS_AUDIO_SWR_WSA3_CGCR] = { 0x300c, 1 },
> +	[LPASS_AUDIO_SWR_WSA4_CGCR] = { 0x301c, 1 },
> +};
> +
> +static const struct regmap_config lpass_audiocc_glymur_regmap_config = {
> +	.reg_bits = 32,
> +	.reg_stride = 4,
> +	.val_bits = 32,
> +	.name = "lpass-audio-csr",
> +	.max_register = 0x1000,

^ needs a bump 

with that

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>

Konrad