Re: [PATCH v2 4/4] clk: qcom: Add lpass clock controller driver for Glymur

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 9/25/26 10:46 AM, Srinivas Kandagatla wrote:
> Add support for the lpass clock controller found on Glymur based devices.
> This would allow lpass peripheral loader drivers to control the clocks and
> bring the subsystems out of reset.
> 
> Currently this patch only supports resets as the Q6DSP is in control of
> LPASS IP which manages most of the clocks via Q6PRM service on GPR rpmsg
> channel.
> 
> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@oss.qualcomm.com>
> Reviewed-by: Abel Vesa <abel.vesa@oss.qualcomm.com>
> ---
>  drivers/clk/qcom/lpasscc-glymur.c | 21 +++++++++++++++++++++
>  1 file changed, 21 insertions(+)
> 
> diff --git a/drivers/clk/qcom/lpasscc-glymur.c b/drivers/clk/qcom/lpasscc-glymur.c
> index 356625dce99e..eda13686850c 100644
> --- a/drivers/clk/qcom/lpasscc-glymur.c
> +++ b/drivers/clk/qcom/lpasscc-glymur.c
> @@ -37,10 +37,31 @@ static const struct qcom_cc_desc lpass_audiocc_glymur_reset_desc = {
>  	.num_resets = ARRAY_SIZE(lpass_audiocc_glymur_resets),
>  };
>  
> +static const struct qcom_reset_map lpasscc_glymur_resets[] = {
> +	[LPASS_AUDIO_SWR_TX_CGCR] = { 0xa028, 1 },

GPT says this register doesn't exist

Konrad