[PATCH Resend] gpio/gpio-stmpe: Fix the value returned by _get_value routine

[Viresh Kumar <viresh.kumar@st.com>]

From: Bhupesh Sharma <bhupesh.sharma@st.com>

The present _get_value routine returns the contents of the GPIO Monitor Pin
Status Register(GPMR) starting from the bit whose value is requested to BIT 0
(irrelevant bits are replace by 0).

For e.g. if we request the value of GPIO 6 in the earlier implementation the
value returned is:

	BIT6 followed by 6 0's

whereas it should just return BIT6.

This patch addresses the same.

Signed-off-by: Bhupesh Sharma <bhupesh.sharma@st.com>
Reviewed-by: Viresh Kumar <viresh.kumar@st.com>
---
Changes in Resend: Commit log fixed

 drivers/gpio/gpio-stmpe.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index 094c5c4..dce3472 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -54,7 +54,7 @@ static int stmpe_gpio_get(struct gpio_chip *chip, unsigned offset)
 	if (ret < 0)
 		return ret;
 
-	return ret & mask;
+	return !!(ret & mask);
 }
 
 static void stmpe_gpio_set(struct gpio_chip *chip, unsigned offset, int val)
-- 
1.7.8.110.g4cb5d